Eur. Phys. J. Appl. Phys. 33, 23-33 (2006)
https://doi.org/10.1051/epjap:2006004

Direct torque control with an optimized observer for multi-machine systems

¹ Laboratoire des Systèmes Électriques, National Engineer School of Tunis, LSE-ENIT, BP 37, Le Belvédère, 1002 Tunis, Tunisia
² ESSTT-GE, BP 56, Monteleury, 1008 Tunis, Tunisia
³ Laboratoire d'Électrotechnique et d'Électronique Industrielle (LEEI), UMR-CNRS, 2 rue Camichel, BP 7122, 31071 Toulouse Cedex 7, France

Corresponding authors: This email address is being protected from spambots. You need JavaScript enabled to view it. This email address is being protected from spambots. You need JavaScript enabled to view it.

Received: 30 March 2004
Revised: 28 July 2005
Accepted: 29 September 2005
Published online: 18 January 2006

Abstract

The first purpose of this work is to design a new observation technique for the Direct Torque Control (DTC). We put emphasis on robustness especially at very low speed, which represents the basic problem of the DTC operating, and on the optimization of the time computing. The reduced order observer is defined by decoupling the full order one in and axis. The second basic aim of this paper is to apply the DTC strategy to multi-machine multi-inverter industrial systems. Speed and tension controls are designed; their performances and parameter robustness are analyzed and compared with those obtained with a Flux Oriented Control (FOC). Mechanical and electrical couplings constitute the principal operation difficulty of these systems mainly when one of the machines is perturbed.