Eur. Phys. J. Appl. Phys. 30, 3-6 (2005)
https://doi.org/10.1051/epjap:2005014

Selective emitters diffusion using an air belt furnace

Laboratoire des Cellules Photovoltaïques, Unité de Développement de la Technologie du Silicium, 2 boulevard Frantz Fanon, BP 399, Alger-Gare, Algeria

Corresponding author: benyahiabedra@hotmail.com

Received: 14 June 2004
Revised: 9 October 2004
Accepted: 22 October 2004
Published online: 28 January 2005

Abstract

A new and simple process for the selective emitter realization was developed on multicrystalline silicon wafers. This material is in competition with single-crystal silicon since it is able to lead to similar performances with a reduction in the cost of solar cell realization. This work is centred on the study of emitter area of a photovoltaic cell and the possibilities to obtain a selective emitter in only one step while avoiding the use of chemicals. This would make substantial economies on the rejections treatment which became a capital environmental factor. A structure with selective emitter consists of a heavy doping under the metallic contacts, leaving weak the surface concentration between the grid lines. This allows a good surface passivation while keeping a good contact resistance for screen printed lines. The advantages of such a structure could be observed by quantum efficiency measurements yield where the benefit appears in the UV-VIS range of the solar spectrum.