Eur. Phys. J. Appl. Phys. 36, 111-117 (2006)
https://doi.org/10.1051/epjap:2006117

Study on preferred crystal orientations of Mg-Zr-O composite protective layer in AC-PDP

¹ Advanced Display Research Center, Institute of Industrial Science, The University of Tokyo, Japan
² Key laboratory for Physical Electronics and Devices of the Ministry of Education, Xi'an Jiaotong University, P.R. China
³ Key laboratory of Opto-Electronic Technology and Intelligent Control of Ministry of Education, Lanzhou Jiaotong University, P.R. China

Corresponding author: guobg@iis.u-tokyo.ac.jp

Received: 15 February 2005
Revised: 10 May 2006
Accepted: 1 August 2006
Published online: 11 October 2006

Abstract

In order to study the preferred crystal orientations of Mg-Zr-O composite protective layers in PDP, Mg-Zr-O composite protective layers were deposited by Electron-beam Evaporator using (MgO+ZrO₂) powder mixture as evaporation source material. X-ray diffractometer (XRD) was used to determine preferred crystal orientations of Mg-Zr-O composite protective layers, surface morphologies of films were analyzed by FESEM and voltage characteristics were examined in a testing macroscopic discharge cell of AC-PDP. On the basis of experimental analysis, the influence of oxide addition and deposition conditions on preferred orientations of Mg-Zr-O composite protective layers were investigated. The results showed that the preferred orientations of Mg-Zr-O films were determined by lattice distortion of MgO crystal. The deposition conditions have great effects on the preferred orientations of Mg-Zr-O films. The preferred orientations affect voltage characteristics through affecting surface morphology of Mg-Zr-O films. A small amount of Zr solution in MgO can decrease firing voltage compared with using pure MgO film. Firing voltage is closely related with the [ ZrO₂/(MgO+ZrO₂)] ratio of evaporation source materials.